Extra Heat Pack - Q2 series

Extra Heat Pack — Q2 Python Burner + adjustable LPG regulator and hose

Two parts. One problem: your Weber Q only uses a third of its plate properly.

The stock burner is a straight tube. It heats a strip down the middle and leaves the rest of the plate to catch up, which it never does. The stock regulator runs one fixed pressure, so your knobs can throttle the flame but can't shift the range it works in.

That's why a Q2 has a hot corner and a cold half, and why the lowest setting still won't sit low enough to roast anything.

This pack replaces both.

The Python Burner — heat across the whole plate

The flame loops the perimeter and returns through the centre, feeding gas ports directly under the middle of the cooking area. The dead zone goes away. You get the full Q2 surface at cooking temperature instead of crowding everything onto the one spot that works.

Fits Q200, Q220, Q2000 and Q2200 on the original mounting points. Five-minute swap.

The adjustable regulator — control over the whole range

Set your baseline pressure at the bottle instead of accepting whatever the fixed regulator hands you. Dial it down and the entire operating range comes down with it, into the territory roasting and slow cooking need. Dial it back to standard for everyday grilling.

POL inlet, 3/8" SAE female flare outlet, 1200 mm.

Why they work together

The burner decides where the heat goes. The regulator decides how much there is. Fix one and you notice the other — an even plate makes it obvious your low setting isn't low, and a proper low setting is wasted if half the plate is cold anyway.

Done together, the barbecue behaves like a cooker rather than a hotplate with a lid.

What's included

• 1 × Python Burner for Weber Q2 — spiral 304 stainless burner tube
• 1 × adjustable LPG regulator and hose assembly, POL to 3/8" SAE, 1200 mm

⚠️ Check before ordering

• Confirm your Weber is a Q200, Q220, Q2000 or Q2200
• Confirm your bottle valve is POL and your inlet is 3/8" SAE female flare
• Set the regulator to your appliance's rated pressure for normal use. The adjustment is for going down from standard, not up.
• Leak-test every joint with soapy water before lighting. Never test with a flame.
• Doesn't fit? We will replace it with one that does, no questions asked.
• 30-day satisfaction guarantee.
• Free shipping across Australia.
• Trusted by 5,000+ Weber owners across Australia.